Removal Procedure
- To remove the passenger side high beam headlamp bulb, refer to Headlamp Replacement .
- Twist the headlamp bulb (3 or 4) counter clockwise until the retainer tabs are released.
- Pull the bulb straight out to remove.
- Disconnect the bulb from the wire harness.
Caution: Halogen bulbs contain gas under pressure. Handling a bulb improperly
could cause it to shatter into flying glass fragments. To help avoid personal
injury:
• Turn off the lamp switch and allow the bulb to cool before changing
the bulb. • Leave the lamp switch OFF until the bulb change is complete. • Always wear eye protection when changing a halogen bulb. • Handle the bulb only by its base. Avoid touching the glass. • Keep dirt and moisture off the bulb. • Properly dispose of the used bulb. • Keep halogen bulbs out of the reach of children.
To replace all other headlamp bulbs go to step 2.
Installation Procedure
- Install the wire harness to the headlamp bulb.
- Install the headlamp bulb (3 or 4) into the headlamp assembly (1).
- Twist the bulb clockwise until the retainers click into place.
- Install the headlamp assembly, if necessary. Refer to Headlamp Replacement .
Notice: Avoid touching the bulb or letting the bulb come in contact with anything damp. Oil from your skin or moisture on the bulb can cause the bulb to explode when the bulb is turned on. If either comes in contact with the bulb, clean the bulb with alcohol or a suitable degreaser and wipe the bulb dry.
