Removal Procedure
- Disable the SIR system. Refer to Disabling the SIR System in SIR.
- Remove the fasteners securing the seat cushion to the adjuster track. Refer to Front Seat Cushion Replacement .
- Lift the front of the seat cushion up in order to gain access to the memory seat module.
- Disconnect the electrical connectors from the memory seat module.
- Remove the fasteners securing the memory seat module to the seat cushion frame.
- Remove the memory seat module from the bottom of the seat cushion.
Caution: Refer to SIR Handling Caution in the Preface section.
Notice: Note the correct routing of the electrical wiring. Failure to reinstall the wiring properly could result in damage to the wiring.
Installation Procedure
- Position the memory seat module to the bottom of the seat cushion.
- Install the memory seat module fasteners.
- Install the electrical connectors to the memory seat module.
- Ensure the wiring harness is positioned in the same location in which it was removed.
- Install the seat cushion. Refer to Front Seat Cushion Replacement .
- Enable the SIR system. Refer to Enabling the SIR System in SIR.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the fasteners to 2 N·m (18 lb in).
