GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Pontiac 🢒 2002 🢒 Bonneville 🢒 Suspension 🢒 Automatic Level Control 🢒 Diagnostic System Check - Automatic Level Control

Test Description

The number(s) below refer to the step number(s) on the diagnostic table.

  1. Lack of communication may be due to a partial malfunction of the class 2 serial data circuit or due to a total malfunction of the class 2 serial data circuit. The specified procedure will determine the particular condition.

    2.

  2. The symptom list in Symptoms will determine the correct diagnostic procedure to use.

    3.

  3. The presence of DTCs which begin with "U" indicate some other module is not communicating. The specified procedure will compile all the available information before tests are performed.

Step

Action

Yes

No

1

Install a scan tool.

Does the scan tool power up?

Go to Step 2

Go to Scan Tool Does Not Power Up in Data Link Communications

2

  1. Turn ON the ignition, with the engine OFF.
  2. Attempt to establish communication with the Rear Integrated Module (RIM).

Does the scan tool communicate with the RIM?

Go to Step 3

Go to Scan Tool Does Not Communicate with Class 2 Device in Data Link Communications

3

Check for DTCs.

Does the scan tool display any DTCs?

Go to Step 4

Go to Symptoms - Automatic Level Control

4

Does the scan tool display any DTCs which begin with a "U"?

Go to Scan Tool Does Not Communicate with Class 2 Device in Data Link Connector Diagnosis

Go to Step 5

5

Does the scan tool display DTC B1007 or B1009?

Go to Diagnostic Trouble Code (DTC) List in Body Control System

Go to Step 6

6

Does the scan tool display DTC B1327?

Go to Diagnostic Trouble Code (DTC) List in Engine Electrical

Go to Diagnostic Trouble Code (DTC) List