GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Pontiac 🢒 2002 🢒 Bonneville 🢒 Body and Accessories 🢒 Retained Accessory Power 🢒 Diagnostic System Check - Retained Accessory Power

Test Description

The numbers below refer to the step numbers on the diagnostic table.

  1. Lack of communication may be due to a partial malfunction of the class 2 serial data circuit or due to a total malfunction of the class 2 serial data circuit. The specified procedure will determine the particular condition.

    2.

  2. This step tests for valid system power moding in all ignition switch positions.

    3.

  3. The presence of DTCs which begin with "U" indicate some other module is not communicating. The specified procedure will compile all the available information before tests are performed.

Step

Action

Yes

No

1

Install a scan tool.

Does the scan tool power up?

Go to Step 2

Go to Scan Tool Does Not Power Up in Data Link Communications

2

  1. Turn ON the ignition, with the engine OFF.
  2. Attempt to establish communication with the following modules:
    3. • The dash integration module (DIM)
    • The rear integration module (RIM)

Does the scan tool communicate with all the modules?

Go to Step 3

Go to Scan Tool Does Not Communicate with Class 2 Device in Data Link Communications

3

Important: Open the driver door and leave it open during this test. This will disable the RAP power mode and eliminate this power mode from the power mode parameter list.

Important: Important: The engine may start during the following step. Turn OFF the engine as soon as you have observed the Crank power mode.

  1. Access the Class 2 Power Mode parameter in the Diagnostic Circuit Check menu on the scan tool.
  2. Rotate the ignition switch through all positions while observing the Class 2 Power Mode parameter.

Does the Class 2 Power Mode parameter reading match the ignition switch position for all switch positions?

Go to Step 4

Go to Power Mode Mismatch in Body Control System

4

Select the DIM and the RIM display DTCs function on the scan tool.

Does the scan tool display any DTCs?

Go to Step 5

Go to Step 8

5

Does the scan tool display any DTCs which begin with a "U"?

Go to Scan Tool Does Not Communicate with Class 2 Device in Data Link Communications

Go to Step 6

6

Does the scan tool display any of the following DTCs?

    • B1000
    • B1004
    • B1007
    • B1009
    • B1010
    • B1390
    • B1422

Go to Diagnostic Trouble Code (DTC) List in Body Control System

Go to Step 7

7

Does the scan tool display DTC B1327?

Go to Diagnostic Trouble Code (DTC) List in Engine Electrical

Go to Step 8

8

Test the courtesy lamps for proper operation. Refer to Interior Lighting Systems Description and Operation in Lighting Systems. Do the courtesy lamps operate properly?

Go to Symptoms - Retained Accessory Power

Go to Diagnostic System Check - Lighting Systems in Lighting Systems