GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Pontiac 🢒 2002 🢒 Bonneville 🢒 General Information 🢒 General Information 🢒 Stabilizer Shaft Link Replacement

Removal Procedure

    Object Number: 105020 Size: SH
  1. Raise the vehicle and support by the frame allowing the control arms to hang free. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Remove the stabilizer link bolts.
  3. Remove the stabilizer link.

Installation Procedure

    Object Number: 105020 Size: SH

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  1. Loosely install the stabilizer link insulators, washers, nut and bolt.

    2. Tighten
    Tighten the stabilizer link nut to 17 N·m (13 lb ft).

  2. Lower the vehicle.