Step | Action | Yes | No |
|---|---|---|---|
1 | Did you perform the Diagnostic System Check? | Go to Step 2 | |
2 | Press each button of the transmitter one at a time. Does the system operate normally? | Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems | Go to Step 3 |
3 | Lock and unlock the door locks using the controls inside the vehicle. Do the locks operate properly? | Go to Step 4 | Go to Diagnostic System Check - Door Systems in Doors |
4 | Operate the rear compartment release and the fuel door release from the controls inside the vehicle. Do the rear compartment release and the fuel door release operate properly? | Go to Step 5 | Go to Symptoms - Body Rear End in Body Rear End |
5 |
Important: Ensure that the keyless entry transmitter is the correct model for the vehicle remote system. A wrong model transmitter may pass this test, but will not activate the vehicle remote system.
Does a tone sound and the green light illuminate on the J 43241 after each button is pressed? | Go to Step 10 | Go to Step 6 |
6 | Do any of the buttons on the transmitter sound the tone and illuminate the green light when pressed? | Go to Step 9 | Go to Step 7 |
7 | Replace the transmitter battery. Refer to Transmitter Battery Replacement . Did you complete the replacement? | Go to Step 8 | -- |
8 |
Does a tone sound and the green light illuminate on the J 43241 after each button is pressed? | Go to Step 10 | Go to Step 9 |
9 | Replace the transmitter. Did you complete the replacement? | Go to Step 10 | -- |
10 |
Important: All transmitters which are to be recognized by the remote control door lock receiver (RCDLR) must be programmed in a single programming sequence. If the system is placed in program mode it will erase all previously programmed transmitters upon the receipt of the programming signal from the first transmitter. Perform the programming procedure. Refer to Transmitter Programming . Did the locks cycle to lock then unlock? | Go to Step 12 | Go to Step 11 |
11 |
Important: When replacing the remote control door lock receiver (RCDLR), perform the transmitter programming procedure. Replace the RCDLR. Refer to Remote Control Door Lock Receiver Replacement . Did you complete the replacement? | Go to Step 12 | -- |
12 | Operate the system in order to verify the repair. Did you correct the condition? | System OK | Go to Step 3 |
