GM Service Manual Online
For 1990-2009 cars only

Tools Required

J 43300 Torque Rod Adjuster

Removal Procedure

    Caution:  When a rear compartment lid hold open device is being removed or installed, provide alternate support to avoid the possibility of damage to the vehicle or personal injury.


    Object Number: 663095  Size: SH
  1. Open and support rear compartment lid.
  2. Remove the front rear compartment trim panel. Refer to Rear Compartment Trim Panel Replacement .
  3. Note the location of the torque rod in the adjustment bracket for reinstallation.
  4. Use the J 43300 in order to disconnect the torque rod from the adjustment bracket.
  5. 4.1. Install the J 43300  (1) over the end of the torque rod.
    4.2. Install a ratchet wrench extension (2) for added leverage.
    4.3. Pry rearward, releasing the torque rod from the adjuster bracket.
    4.4. Carefully move the J 43300 toward the front of the vehicle releasing the pressure on the torque rod.
  6. Slide the opposite end of torque rod out of the rear compartment hinge.
  7. Remove the torque rod from the hinge.

Installation Procedure


    Object Number: 663095  Size: SH
  1. Install the torque rod into the rear compartment hinge.
  2. Use the J 43300 in order to install the torque rod to the notch in the adjustment bracket noted during the removal procedure.
  3. 2.1. Install the J 43300  (1) over the end of the torque rod.
    2.2. Install a ratchet wrench extension (2) for added leverage.
    2.3. Pry rearward on the J 43300 and install the torque rod into the notch in the adjustment bracket.
    2.4. Remove the J 43300 off the end of the torque rod.
  4. Inspect the operating effort of the rear compartment lid.
  5. Adjust the torque rods as necessary. Refer to Rear Compartment Lid Adjustment .
  6. Install the rear compartment trim. Refer to Rear Compartment Trim Panel Replacement .