For 1990-2009 cars only
- Set the parking brake and chock the wheels.
- Remove the range selector cable terminal from the transmission manual shaft lever pin.
- Pry on the range selector cable terminal at the manual shaft lever pin with an appropriate tool. Prying or pulling up on any other part of the range selector cable may result in damage to the range selector cable .
- Fully lift the adjuster lock button. Ensure that the adjuster is free to move.
- Place the transmission manual shaft lever in (N) Neutral. In order to find (N) Neutral, rotate the lever fully counterclockwise to (P) Park, and then clockwise 2 clicks into (N) Neutral.
- Place the gear shifter inside the car to the (N) Neutral position.
- If adjusting a column shift vehicle, rotate the shift lever to the LOW 1 position, fully down. Push forward and upward slowly past the first click, which is overdrive, until it stops solidly at the second click. It is in (N) Neutral.
- Underhood, grasp the range selector cable terminal and pull it toward the pin on the manual shaft lever. The range selector cable adjuster spring should compress as the terminal is moved toward the pin.
- Attach the pin to the lever by pushing down carefully until it snaps.
- Press the adjuster lock button down flush with the adjuster body.
- Shift to (P) Park and release the parking brake while applying the service brake.
- Start the engine and assure all of the indicated gear positions match the vehicle response.
Notice: Adjust the shift control cable only while the transaxle and the gear selector are in NEUTRAL. Failure to do so may cause mis-adjustment.
Do not pull the terminal beyond the pin and then push back. This action could move the shifter out of (N) Neutral.
