GM Service Manual Online
For 1990-2009 cars only

Circuit Description

The first design digital radio antenna is connected to the digital radio receiver by 2 coax cables. One coax carries the satellite signal, the other coax carries the terrestrial signal. The antenna cable for the satellite antenna also provides a path for DC current for powering the antenna. The second design digital radio antenna is connected to the digital radio receiver by 1 coax cable. This coax carries the satellite and the terrestrial signal.

DTC Descriptor

This diagnostic procedure supports the following DTC:

DTC B1259 Antenna Ground Circuit

Conditions for Running the DTC

This test is run every 300 milliseconds.

Conditions for Setting the DTC

The digital radio receiver detects an antenna fault.

Action Taken When the DTC Sets

The radio displays "No XM Signal."

Conditions for Clearing the DTC

    • The condition must be corrected.
    • The DTC clears after 100 malfunction free ignition cycles.

Test Description

The number below refers to the step number on the diagnostic table.

  1. Due to current limiting capabilities in the module, an antenna cable shorted to ground could still show 1,200-1,800 millivolts.

Step

Action

Values

Yes

No

Schematic Reference: Radio/Audio System Schematics

Connector End View Reference: Entertainment Connector End Views

1

Did you perform the Diagnostic System Check - Vehicle?

--

Go to Step 2

Go to Diagnostic System Check - Vehicle in Vehicle DTC Information

2

With a scan tool, observe the digital radio antenna in the digital radio receiver data list.

Does the scan tool indicate that the digital radio antenna is within the specified range?

17-63 mA

Go to Step 7

Go to Step 4

3

Test the antenna cables for a short to ground. Refer to Circuit Testing in Wiring Systems.

Did you find the condition?

--

Go to Step 6

Go to Step 7

4

  1. Disconnect the antenna cables from the digital radio receiver.
  2. Measure the voltage from the center conductor of the inboard antenna connector on the digital radio receiver to one of the case screws.

Does the voltage measure within the specified range?

4.5-5.5 V

Go to Step 5

Go to Step 7

5

Test the antenna cables for an open or high resistance. Refer to Circuit Testing in Wiring Systems.

Did you find the condition?

--

Go to Step 6

Go to Step 9

6

Replace the antenna cables. Refer to Digital Radio Antenna Cable Replacement .

Did you complete the replacement?

--

Go to Step 11

--

7

Inspect for poor connections at the digital radio receiver. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.

Did you find and correct the condition?

--

Go to Step 11

Go to Step 8

8

Replace the digital radio receiver. Refer to Control Module References in Computer/Integrating Systems for replacement, setup, and programming.

Did you complete the replacement?

--

Go to Step 11

--

9

Inspect for poor connections at the digital radio antenna. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.

Did you find and correct the condition?

--

Go to Step 11

Go to Step 10

10

Replace the digital radio antenna. Refer to Cellular Communications/Digital Radio Antenna Replacement in Cellular Communication.

Did you complete the replacement?

--

Go to Step 11

--

11

  1. Use the scan tool in order to clear the DTCs.
  2. Operate the vehicle within the Conditions for Running the DTC as specified in the supporting text.

Does the DTC reset?

--

Go to Step 2

System OK