Condition: Rattles from T-Top latch area on CC1 equipped vehicles.
Cause: C-Clip used to retain latch pin rattles ONLY when top is installed on vehicle and latched.
1. Remove latch handle and garnish molding from T-Top panel.
2. Apply cloth body tape (i.e. Duct tape) around latch pin over C-Clip groove as shown in Figure 1.
3. Repeat step two for remaining latch pin.
4. Reinstall garnish and latch handle.
5. Repeat steps 1-4 for opposite T-Top panel.
Labor Operation Number: T1758 Labor Time: 0.4 Hours
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
Condition: Rattle from rear compartment area.
Cause: Rear compartment cargo cover ends rattle against rear seatbelt retractor cover.
Correction: Install adhesive-backed felt or "loop" guide of a strip of hook-and-loop type fastener on cargo cover ends in area of contact.
Labor Operation Number: T1759 Labor Time: 0.2 Hours
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
Condition: Rattle from right rear area of vehicle on G80 equipped vehicles.
Cause: Mispositioned cardboard jacket on spare tire inflator canister.
Correction: Position cardboard jacket so that bottom edge of jacket is flush with bottom edge of inflator canister.
Labor Operation Number: E0620
Labor Time 0.3 Hours Use Trouble Code 92
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
Condition: Squeak from right rear seat area (drum brake vehicles only)
Cause: Right side park brake cable rubs against control arm.
Correction: Remove bracket securing cable to body at right rear frame rail. Bend (straighten) bracket locating tab and reinstall bracket and cable as shown in Figure 2.
Labor Operation Number: T1757 Labor Time: 0.3 Hours
Condition: Rattles from rear area of vehicle on rough roads.
Cause: Upper coils of rear springs may contact each other due to spring orientation.
Correction: Use Service Manual procedures (spring removal and reinstallation) to reposition (rotate) both right and left springs to orient LOWER spring wire ends (tails) of both springs pointing FORWARD.
Labor Operation Number: E5027 Labor Time : 0.4 Hours Use Trouble Code 92
General Motors bulletins are intended for use by professional technicians, not a "do-it-yourselfer". They are written to inform those technicians of conditions that may occur on some vehicles, or to provide information that could assist in the proper service of a vehicle. Properly trained technicians have the equipment, tools, safety instructions and know-how to do a job properly and safely. If a condition is described, do not assume that the bulletin applies to your vehicle, or that your vehicle will have that condition. See a General Motors dealer servicing your brand of General Motors vehicle for information on whether your vehicle may benefit from the information.