NEW LOWER FRONT FENDER MOLDING (LEFT SIDE ONLY)

SUBJECT: LOWER FRONT FENDER MOULDING (LEFT SIDE ONLY) LARGER LOCATING TAB (REVISED SERVICE PARTS)

VEHICLES AFFECTED: 1991-92 PONTIAC TRANS AM AND GTA

A new service part has been released for the 1991-92 Pontiac Trans AM and GTA lower front fender moulding (left side only). The new part has a larger tab on the moulding and a larger mating slot on the fascia.

Original Moulding Kit, P/N 12508855 will be replaced by P/N 12517757. When using new moulding kit, P/N 12517757 on past models, the moulding tab must be cut to a smaller size of 10.Omm as shown in View A.

General Motors bulletins are intended for use by professional technicians, not a "do-it-yourselfer". They are written to inform those technicians of conditions that may occur on some vehicles, or to provide information that could assist in the proper service of a vehicle. Properly trained technicians have the equipment, tools, safety instructions and know-how to do a job properly and safely. If a condition is described, do not assume that the bulletin applies to your vehicle, or that your vehicle will have that condition. See a General Motors dealer servicing your brand of General Motors vehicle for information on whether your vehicle may benefit from the information.