GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Pontiac 🢒 1998 🢒 Firebird 🢒 Brakes 🢒 Hydraulic Brakes 🢒 Stabilizer Shaft Link Replacement

Removal Procedure
  1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Remove the nut (7).

    3. Object Number: 181095 Size: SH
  3. Remove the link (3).

Installation Procedure
  1. Install the sleeve (5) between the lower control arm (4) and the stabilizer shaft (6).

    2. Object Number: 181095 Size: SH
  2. Install the link (3) through the lower control arm (4), the sleeve (5), and the stabilizer shaft (6).

    3. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  3. Install the nut (7)

    4. Tighten
    Tighten the nut (7) to 23 N·m (17 lb ft).

  4. Lower the vehicle.