Tools Required

J 25034-C Pulley Pump Remover

1. Remove the air intake resonator and mass airflow assembly (LS1 only).
2. Remove the serpentine belt.



3. Use the J 25034-C in order to remove the steering pulley from the power steering pump.

Tools Required

J 25033-C Pulley Pump Installer.

Important: 

•	3.8 Liter Engine: Ensure that the face of the pulley hub is flush with the end of the pump shaft before you apply a load to the pulley hub.

•	5.7 Liter Engine: Ensure that the pulley hub shoulder bottoms out completely on the pulley shaft before you apply a load to the pulley hub.

•	Ensure that the pulley goes on snug when installing the pulley with the special tool. If the pulley installs onto the pump shaft too easily, it will not relay engine power to the pump and should be replaced.

1. Use the J 25033-C in order to install the power steering pulley (1) to the power steering pump (2).
2. Install the air intake resonator and mass airflow assembly (LS1 only).
3. Install the serpentine belt.
4. Check power steering operation and visibly check pulley for any irregular wobble when operating.