Tools Required

1. Install the dimmer switch assembly (3) to the ignition switch assembly (4).
2. Install the hexagon washer head tapping screw (1) to the dimmer switch assembly (3).
3. Tighten the hexagon washer head tapping screw (1) finger tight.
4. Install the washer head screw (2) to the dimmer switch assembly (3).
5. Tighten the washer head screw (2) finger tight.
6. Insert the dimmer switch rod into the slot on the dimmer switch assembly (3).



7. Adjust the dimmer switch assembly (1) following these steps:

7.1.	Install a 3/32 inch drill bit into the hole (1) on the dimmer switch assembly to limit travel.

7.2.	Position the dimmer switch assembly onto the column and push it against the dimmer switch actuator rod to remove all the lash.

7.3.	Remove the drill bit.




8. Tighten the hexagon washer head screw (1).

Tighten
Tighten the hexagon washer head screw to 2.5 N·m (22 lb in).

9. Tighten the washer head screw (2).

Tighten
Tighten the washer head screw to 4 N·m (35 lb in).

10. Insert the vehicle wire harness into the dimmer switch assembly (3).
11. Remove the steering column and J 41352 from the vise.
12. Remove J 42640 from the column.