Tool Required
J 39246 Tilt Spring Compressor

1. Remove the lock housing cover and sleeve assembly. Refer to Lock Housing Assembly - Disassemble - Off Vehicle .



2. Seat the counterbore of J 39246 over the steering shaft assembly (1).
3. Thread and seat the standard hexagon nut (2) onto the steering shaft assembly (1).
4. Thread the hexagon nut (2) until it contacts the block of J 39246 .



5. Insert the square end (2) of J 39246 into the spring retainer (1) and seat.



6. Rotate the tool bolt clockwise with the wrench until it contacts the surface of the tool block.
7. Make a ¼  turn counter clockwise to the hexagon section on the end of the tool bolt.
8. Unscrew the tool bolt until the wheel tilt spring and the spring retainer (1) are free.



9. Remove the spring retainer (2) from the steering column housing assembly.
10. Remove the wheel tilt spring (1) from the steering column housing assembly.
11. Remove the spring guide (3) from the steering column housing assembly.