Tools Required

1. Remove the inflatable restraint steering wheel module. Refer to Steering Wheel Inflator Module Replacement .
2. Remove the nut (3).
3. Remove the horn lead (5).

Notice: When removing the steering wheel, use only the specified steering wheel puller. Under no conditions should the end of the steering column shaft be hammered on, as hammering could loosen the plastic injections which maintain steering column rigidity.

Notice: When attaching J 1859-A and J 38720 to the steering wheel, use care to prevent threading J 39720 (bolts) all the way through the steering wheel hub into the SIR coil and damaging the SIR coil.

4. Use a J 1859-A and a J 38720 in order to remove the steering wheel (2).
5. Remove the steering wheel horn switch.

1. Route the SIR coil electrical connector to the steering wheel (2).
2. Install the steering wheel horn switch.

Important: Align the tooth on the steering wheel with the block tooth on the steering column shaft within one female serration.

3. Install the steering wheel (2).
4. Install the horn lead (5).

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

5. Install the nut (3).

Tighten
Tighten the nut to 43 N·m (32 lb ft).

6. Install the inflatable restraint steering wheel module. Refer to Steering Wheel Inflator Module Replacement .