Rear Bumper Fascia Replacement Chevrolet

1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.



2. Remove the push-in retainers located under the fascia.



3. Remove the bumper fascia nuts.



4. Remove the bumper fascia bolts.
5. Lower the vehicle.
6. Remove the rear end finish panel.
7. Remove the spare tire and jack.
8. Remove the upper push-in retainers from the top of the fascia.



9. Remove the harness connector rosebud clip from the fascia.
10. Disconnect the rear body wiring harness connector from the fascia wiring harness connector.
11. Remove the rear bumper fascia from the vehicle.

1. Install the rear bumper fascia to the vehicle.



2. Connect the rear body wiring harness connector to the rear fascia wiring harness connector.
3. Connect the harness connector rosebud clip to the fascia.
4. Install the upper push-in retainers to the top of the fascia.
5. Install the spare tire and jack.
6. Install the rear end finish panel.
7. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.



8. Install the bumper fascia bolts.

Tighten
Tighten the bumper fascia bolts to 2 N·m (18 lb in).




9. Remove the bumper fascia nuts.

Tighten
Tighten the bumper fascia nuts to 6 N·m (53 lb in).




10. Install the push-in retainers located under the fascia.
11. Lower the vehicle.

Rear Bumper Fascia Replacement Pontiac

1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.



2. Remove the push-in retainers located under the fascia.



3. Remove the bumper fascia nuts.



4. Remove the bumper fascia bolts.
5. Lower the vehicle.
6. Remove the rear end finish panel.
7. Remove the spare tire and jack.



8. Remove the push-in retainers from the top of the fascia.



9. Remove the harness connector rosebud clip from the fascia.
10. Disconnect the rear body wiring harness connector from the fascia wiring harness connector.
11. Remove the rear bumper fascia from the vehicle.

1. Install the rear bumper fascia to the vehicle.



2. Connect the rear body wiring harness connector to the rear fascia wiring harness connector.
3. Connect the harness connector rosebud clip to the fascia.



4. Remove the push-in retainers from the top of the fascia.
5. Install the spare tire and jack.
6. Install the rear end finish panel.
7. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.



8. Install the bumper fascia bolts.

Tighten
Tighten the bumper fascia bolts to 2 N·m (18 lb in).




9. Install the bumper fascia nuts.

Tighten
Tighten the bumper fascia nuts to 6 N·m (53 lb in).




10. Remove the push-in retainers located under the fascia.
11. Lower the vehicle.