For 1990-2009 cars only
- Depending on the location of the water leak, you may have to remove the trim molding or headliner to repair the leak.
- Cut out a portion of the adhesive in the leak area from inside or outside the vehicle.
- Clean and remove all loose particles from the area.
- Caulk the adhesive between the window and the pinchweld flange where the old adhesive has been cut away.
- Mist the newly applied adhesive with water to cure the adhesive.
- Test for leaks.
- Install the molding(s).
- Allow the adhesive to dry for several hours.
- Test for water leaks. Refer to the appropriate procedure from the following list:
Feather the adhesive out to several inches past the leak area. Use urethane adhesive from GM P/N 12346284 or equivalent.
