Caution: Keep hands, tools, and clothing away from the electric engine coolant fans in order to help prevent personal injury. These fans are electric and can turn on whether or not the engine is running. The fans can start automatically with the ignition in the ON position.

1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection in Engine Electrical.



2. Disconnect the intake air temperature (IAT) and mass airflow (MAF) sensors electrical connectors, if equipped with the 5.7L engine.



3. Remove the air intake duct resonator, if equipped with the 5.7L engine.



4. Disconnect the electrical connector from the intake air temperature (IAT) sensor, if equipped with the 3.8L engine.



5. Remove the air intake duct resonator, if equipped with the 3.8L engine.



6. Disconnect the rosebud clips from the fans.



7. Disconnect the coolant fan electrical connectors from the fans.



8. Remove the air cleaner bolts.
9. Remove the air cleaner.



10. Remove the electric engine coolant fan. The fan will slide off of the radiator.



11. Remove the fan blade nut.

Caution: If a fan blade is bent or damaged in any way, do not repair or reuse the damaged part. Always replace a bent or damaged fan blade. Fan blades that have been damaged can not be assured of proper balance and could fail and fly apart during subsequent use. This creates an extremely dangerous situation.

The fan blades must remain in proper balance. You cannot assure fan blade balance once a fan blade has been bent or damaged. A fan blade that is not in proper balance could fail and fly apart during use, creating an extremely dangerous situation.
12. Remove the fan blade.
13. Inspect for the following conditions:

•	Bent or cracked fan blades

•	Smoothness of the fan blade mating surfaces

•	Remove burrs or other imperfections as necessary

1. Install the fan blade.
2. Install the fan blade nut.

Tighten
Tighten the fan blade nut to 5.5 N·m (49 lb in).




3. Install the electric engine coolant fan. The fan will slide into place on the radiator.



4. Install the air cleaner.
5. Install the air cleaner bolts.

Tighten
Tighten the air cleaner bolts to 12 N·m (106 lb in).




6. Connect the coolant fan electrical connectors to the fans.



7. Connect the rosebud clips to the fans.



8. Install the air intake duct resonator, if equipped with the 3.8L engine.



9. Connect the electrical connector to the IAT sensor, if equipped with the 3.8L engine.



10. Install the air intake duct resonator, if equipped with the 5.7L engine.



11. Connect the IAT and the MAF sensors electrical connectors, if equipped with the 5.7L engine.



12. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection in Engine Electrical.