- Remove the key from the
ignition switch.
- Connect the passenger yellow 2-way connector (C219) located behind
the IP compartment door.
- Install the connector
position assurance (CPA) to the passenger yellow 2-way connector located behind
the IP compartment door.
- Install the right instrument panel insulator. Refer to
Instrument Panel Insulator Replacement
in Instrument
Panel, Gauges and Console.
- Connect the driver yellow
2-way connector (C218) located at the base of the steering column.
- Install the connector
position assurance (CPA) to the driver yellow 2-way connector located at the
base of the steering column.
- Install the left instrument panel insulator. Refer to
Instrument Panel Insulator Replacement
in Instrument
Panel, Gauges and Console.
- Install the AIR BAG fuse
in the IP fuse block.
- Install the IP fuse block access door.
- Staying well away from both air bags, turn the ignition switch
to the RUN position.
10.1. | The AIR BAG warning lamp will flash seven times. |
10.2. | The AIR BAG warning lamp will then turn OFF. |
- Perform the SIR Diagnostic System Check if the AIR BAG warning
lamp does not operate as described. Refer to
SIR Diagnostic System Check
.