For 1990-2009 cars only
Circuit Description
The PCM performs an internal self-test on it's Random Access Memory (RAM) or read/write memory. If this self-test fails, this DTC sets.
Conditions for Running the DTC
| • | The ignition voltage is greater than 10 volts. |
| • | The ignition is ON for 5 seconds. |
Conditions for Setting the DTC
The internal RAM test fails.
Action Taken When the DTC Sets
| • | The PCM will illuminate the malfunction indicator lamp (MIL) during the first trip in which the diagnostic test has been run and failed. |
| • | The PCM will store conditions which were present when the DTC set as Freeze Frame and Failure Records data. |
Test Description
The numbers below refer to the step numbers on the diagnostic table.
Step | Action | Value(s) | Yes | No |
|---|---|---|---|---|
1 | Did you perform the Powertrain On-Board Diagnostic (OBD) System Check? | -- | ||
|
Important:: The replacement PCM must be programmed. Refer to Powertrain Control Module Replacement/Programming . Replace the PCM. Did you complete the replacement? | -- | -- |
