Shoulder Belt Replacement - Rear Trim Cover

1. Unsnap and disconnect the cover (1) from the retractor trim cover (3).
2. Remove the retractor trim cover retainer (2).
3. Remove the cover (1) from the retractor trim cover.

1. Connect the cover (1) to the retractor trim cover.
2. Install the retractor trim cover retainer (2).
3. Install the retractor trim cover (3).

Shoulder Belt Replacement - Rear Retractor Bracket

Caution: The seat belt assembly and/or the bracket assembly must be replaced as a unit only. Do not substitute parts for any reason, or personal injury could result in the event of a collision.

1. Remove the retractor trim cover.



2. Remove the bolt (2) from the rear seat retractor-side belt guide.
3. Remove the bolt (1) from the rear seat retractor-side belt .



4. Remove the retractor from the bracket (2).
5. Remove the bracket bolts (1).
6. Remove the bracket (2).

1. Install the bracket (2).

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Install the bracket bolts (1).

Tighten
Tighten the bolts to 30 N·m (22 lb ft).

3. Connect the retractor to the bracket (2).



4. Install the bolt (1) to the rear seat retractor-side belt.

Tighten
Tighten the bolt to 42 N·m (31 lb ft).

5. Install the bolt (2) to the rear seat retractor-side belt guide.

Tighten
Tighten the bolt to 42 N·m (31 lb ft).

6. Install the retractor trim cover.