Step
| Action
| Value(s)
| Yes
| No
|
|
Important: In order to avoid misdiagnosis, check for powertrain control module (PCM)
DTCs. Refer to Engine Controls.
|
1
|
- Disconnect the starter relay.
- Connect a test lamp between underhood electrical center 2 terminal
C6 and B+.
- While observing the test lamp, turn the ignition switch to the
RUN position.
Does the test lamp light?
| --
|
Go to Step
2
|
Go to Step 6
|
2
|
- Connect a test lamp between underhood electrical center 2 terminal
B4 and ground.
- Depress the clutch pedal (manual transmission).
- Place the vehicle in park (automatic transmission).
- While observing the test lamp, turn the ignition switch to the
START position.
Does the test lamp light?
| --
|
Go to Step
3
|
Go to Step 7
|
3
| Connect a test lamp between underhood electrical center 2 terminal C4
and ground.
Does the test lamp light?
| --
|
Go to Step
4
|
Go to Step 10
|
4
|
- Disconnect circuit 6 (PPL wire) from the starter solenoid.
- Connect a 20A fused jumper from circuit 6 (PPL wire) to ground.
- Connect a test lamp from underhood electrical center terminal
C4 to terminal B6.
Does the test lamp light?
| --
|
Go to Step
5
|
Go to Step 11
|
5
|
- Test circuit 6 for a poor connection at the starter solenoid.
- If the connection is OK, replace the starter motor.
Is the repair complete?
| --
| System OK
| --
|
6
|
- Test for a poor connection in circuit 625 between the body control
module (BCM) and the underhood electrical center 2.
- Test for an open in circuit 625 between the BCM and the underhood
electrical center 2.
- Test circuit 625 for a short to B+.
- If circuit 625 is OK, replace the BCM. Refer to
Body Control Module Replacement
.
Is the repair complete?
| --
| System OK
| --
|
7
| Is the vehicle equipped with a manual transmission?
| --
|
Go to Step 8
|
Go to Step 9
|
8
|
- Test for an open or poor connection in circuit 1443 between the
underhood electrical center 2 terminal B4 and the clutch pedal position switch.
- Test for an open or poor connection in circuit 1035 between the
clutch pedal position switch and C200.
- If the circuits are OK, replace the clutch pedal position switch.
Refer to
Clutch Pedal Position Switch Replacement
.
Is the repair complete?
| --
| System OK
| --
|
9
|
- Test for an open or poor connection in circuit 1443 between the
underhood electrical center 2 terminal B4 and the park neutral position switch.
- Test for an open or poor connection in circuit 1035 between the
park neutral position switch and C200.
- If the circuits are OK, adjust or replace the park/neutral position
switch. Refer to
Park/Neutral Position Switch Replacement
or
Park/Neutral Position Switch Adjustment
.
Is the repair complete?
| --
| System OK
| --
|
10
| Repair the open in circuit 2 between the underhood electrical
center terminal C4 and S183.
Is the repair complete?
| --
| System OK
| --
|
11
| Repair the open or poor connector in circuit 6 between
the starter solenoid and the underhood electrical center 2.
Is the repair complete?
| --
| System OK
| --
|
