Rear Seat Belt Retractor Replacement Coupe
Removal Procedure
- Remove the cargo area front trim panel. Refer to
Cargo Area Front Trim Panel Replacement
in Interior Trim.
- Remove the rear seat cushion. Refer to
Rear Seat Cushion Replacement
in Seats.
- Remove the nut (1)
that attaches the rear seat retractor-side shoulder belt (8) to the
inner wheelhouse panel (2).
- Remove the bolt (7) that attaches the shoulder
belt guide (6) to the rear seat back cushion.
- Remove the bolt (4) and the spacer (3) that attaches
the shoulder belt (5) to the floor panel.
- Remove the rear seat belt retractor (8) from the vehicle.
Installation Procedure
- Install the shoulder belt
anchor plate to the floor panel.
Notice: Use the correct fastener in the correct location. Replacement fasteners
must be the correct part number for that application. Fasteners requiring
replacement or fasteners requiring the use of thread locking compound or sealant
are identified in the service procedure. Do not use paints, lubricants, or
corrosion inhibitors on fasteners or fastener joint surfaces unless specified.
These coatings affect fastener torque and joint clamping force and may damage
the fastener. Use the correct tightening sequence and specifications when
installing fasteners in order to avoid damage to parts and systems.
- Install the shoulder
belt (5) by connecting the bolt (4) and the spacer (3)
to the floor panel.
Tighten
Tighten the bolt to 42 N·m (31 lb ft).
- Install the shoulder belt guide (6) to the rear seat back
cushion with bolt (7).
Tighten
Tighten the bolt to 10 N·m (89 lb in).
- Install the belt retractor (8) to the inner wheelhouse
panel (2) with a nut (1).
Tighten
Tighten the nut to 55 N·m (41 lb ft).
- Install the rear seat cushion. Refer to
Rear Seat Cushion Replacement
in Seats.
- Install the cargo area front trim panel. Refer to
Cargo Area Front Trim Panel Replacement
in Interior Trim.
Rear Seat Belt Retractor Replacement Convertible
Removal Procedure
- Remove the retractor trim cover.
- Remove the rear seat cushion. Refer to
Rear Seat Cushion Replacement
in Seats.
- Remove the bolts (1, 2)
that secure the side shoulder belt to the rear seat retractor.
- Remove the bolt (1)
and the spacer (2) that attaches the belt (3) to the floor panel.
- Remove the rear seat belt (3).
Installation Procedure
- Install the rear seat
belt anchor plate to the floor panel.
Notice: Use the correct fastener in the correct location. Replacement fasteners
must be the correct part number for that application. Fasteners requiring
replacement or fasteners requiring the use of thread locking compound or sealant
are identified in the service procedure. Do not use paints, lubricants, or
corrosion inhibitors on fasteners or fastener joint surfaces unless specified.
These coatings affect fastener torque and joint clamping force and may damage
the fastener. Use the correct tightening sequence and specifications when
installing fasteners in order to avoid damage to parts and systems.
- Install the rear
seat belt (3) to the floor panel using a bolt (1) and a spacer (2).
Tighten
Tighten the bolt to 42 N·m (31 lb ft).
- Install the side shoulder
belt to the retractor using two bolts (1, 2).
Tighten
Tighten the bolts to 42 N·m (31 lb ft).
- Install the rear seat cushion. Refer to
Rear Seat Cushion Replacement
in Seats.
- Install the retractor trim cover.