Driver or Passenger Seat Head Restraint Replacement Base Level

Tools Required

J 39641 Headrest Removal Tool

1. Remove the seatback release knob.
2. Separate the J-retainers at the bottom of the seat.
3. Pull the seat cover past the head restraint posts.
4. Slide the J 39641 up the head restraint posts with the tool tabs fitting into the open slots between the head restraint guide tabs.
5. With the headrest removal tools in place, rotate each tool so the head restraint guide tabs expand outward.



6. Remove the head restraint (3).
7. Remove the shoulder belt guide screws (2), and the shoulder belt guide (1) if required.

1. Install the head restraint (3).
2. Firmly pull down on the seat cover in order to enable the J-retainers at the bottom of the seat to lock together.
3. Install the seatback release knob.
4. Install the shoulder belt guide (1) if required.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

5. Install the shoulder belt guide screws (2) to the guide (1).

Tighten
Tighten the screws to 3 N·m (27 lb in).