Starter Shield Replacement 3.8L Engine

1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
2. Remove the starter motor shield bolts (1, 3) and nut (2).
3. Remove the starter motor shield.

1. Install the starter motor shield

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Install the starter shield nut (2) and bolts (1, 3).

Tighten

•	Tighten to starter motor shield bolt (1) to 30 N·m (22 lb ft).

•	Tighten the starter motor shield bolt (3) and nut (2) to 10 N·m (89 lb in).

3. Lower the vehicle.

Starter Shield Replacement 5.7L Engine

1. Remove the starter motor. Refer to Starter Motor Replacement .
2. Unsnap the starter motor shield from the solenoid.

1. Snap the starter motor shield to the starter solenoid.
2. Install the starter motor. Refer to Starter Motor Replacement .