GM Service Manual Online
For 1990-2009 cars only

Clutch Pressure Plate and Clutch Driven Plate 3.8 L

Removal Procedure


    Object Number: 479575  Size: SH
  1. Remove the manual transmission. Refer to Transmission Replacement in Manual Transmission - M49.
  2. Remove the clutch pressure plate bolts (1).
  3. Remove the clutch pressure plate (2) and driven disc (4) from the dowel pins on the flywheel (3).

Installation Procedure

Tools Required

    • J 33169 Clutch Alignment Arbor
    • J 36660-A Torque Angle Meter

Important: When the clutch driven plate requires replacement, the engine flywheel must also be replaced along with the clutch pressure plate as an assembly.


    Object Number: 441865  Size: SH
  1. Install the clutch pressure plate (2) and driven plate (6) to the dowel pins on the flywheel (5).
  2. Match the gray paint spot (7) on the pressure plate (2) to the X (4) on the flywheel (5).
  3. Install the clutch pressure plate bolts (1) finger tight.
  4. Install the J 33169 in order to align the clutch driven plate to the clutch pilot bearing.
  5. Tighten the clutch pressure plate bolts (1).
  6. Tighten
    Tighten the clutch pressure plate bolts (1) to 20 N·m (15 lb ft). Use the J 36660-A to torque the clutch pressure plate bolts (1) an additional 45 degrees.

  7. Install the manual transmission. Refer to Transmission Replacement in Manual Transmission - M49.

Clutch Pressure Plate and Clutch Driven Plate 5.7 L

Tools Required

J 38836 Pilot Bushing Installer/Clutch Alignment Arbor

Removal Procedure


    Object Number: 441863  Size: SH
  1. Remove the manual transmission. Refer to Transmission Replacement in Manual Transmission - MM6.
  2. Remove the clutch pressure plate bolts (4).
  3. Remove the clutch pressure plate (3) and driven disc (2) from the dowel pins on the flywheel (1).

Installation Procedure

Important: When the clutch driven plate requires replacement, the engine flywheel must also be replaced along with the clutch pressure plate as an assembly.


    Object Number: 71488  Size: SH
  1. Install the clutch pressure plate and driven plate to the dowel pins on the flywheel.
  2. Install the clutch pressure plate bolts finger tight.
  3. Install the J 38836 in order to align the clutch driven plate to the clutch pilot bearing.

  4. Object Number: 71490  Size: SH

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  5. Tighten the clutch pressure plate bolts.
  6. Tighten
    Tighten the clutch pressure plate bolts (in sequence shown) to 70 N·m (52 lb ft).

  7. Install the manual transmission. Refer to Transmission Replacement in Manual Transmission - MM6.