GM Service Manual Online
For 1990-2009 cars only

The keyless entry system is a supplementary vehicle entry device. Radio frequencies or discharged batteries may disable the system.

Keyless entry allows you to operate the following components:

    • The door locks
    • The rear compartment lid release
    • The illuminated entry lamps
    • The panic alarm (instant alarm)

The keyless entry system has the following main components:

    • The transmitters
    • The body control module (BCM)

When you press a button on a transmitter, the transmitter sends a signal to the BCM. The BCM interprets the signal and activates the requested function.

Unlock Driver's Door Only

Momentarily press the UNLOCK button in order to perform the following functions:

    • Unlock the driver's door only.
    • Illuminate the interior lamps for approximately 40 seconds or until the ignition is turned ON.
    • Chirp the horn, if turned ON in personalization.
    • Pulse the park lamps, if turned ON in personalization.
    • Disarm the content theft deterrent (CTD) system, if equipped.

Unlock All Doors (Second Operation)

Momentarily press the UNLOCK button a second time, (within 5 seconds of the first press, in order to perform the following functions:

    • Unlock the passenger door.
    • Illuminate the interior lamps for approximately 40 seconds or until the ignition is turned ON.
    • Pulse the park lamps, if turned ON in personalization.

Lock All Doors

Press the LOCK button in order to perform the following functions:

    • Lock both doors.
    • Immediately turn off the interior lamps.
    • Chirp the horn, if turned ON in personalization.
    • Pulse the park lamps, if turned ON in personalization.
    • Arm the content theft deterrent (CTD) system, if equipped.

Rear Compartment Lid Release

If the vehicle transmission is in PARK or NEUTRAL and the ignition is in the OFF position, 2 resses of the rear compartment release button will open the rear compartment lid.

Alarm

A single press of the panic button performs the following functions:

    • Pulses the horn.
    • Flashes the park lamps for 110 seconds or until one of the following conditions occur:
       - The panic button is pressed again.
       - The ignition switch is turned to the RUN position with a valid key.

Keyless Entry Personalization

The exterior lamps and horn chirp may be personalized as part of the remote activation verification feature. For mode descriptions and programming instructions, refer to Vehicle Personalization in Personalization.

Rolling Code

The keyless entry system uses rolling code technology. Rolling code technology prevents anyone from recording the message sent from the transmitter and using the message in order to gain entry to the vehicle. The term "rolling code" refers to the way that the keyless entry system sends and receives the signals. The transmitter sends the signal in a different order each time. The transmitter and the body control module (BCM) are synchronized to the appropriate order. If a programmed transmitter sends a signal that is not in the order that the BCM expects, then only the panic button will function.