Removal Procedure
- Remove the steering wheel
from the steering column. Refer to
Steering Wheel Replacement
- Insert the ignition key into the lock cylinder.
Leave the key in the LOCK position.
- Remove the lock retaining
screw (2).
- Remove the lock cylinder (1) and harness (4), perform
the following:
| 4.1. | Disconnect the terminal connector from the bulkhead connector. |
| 4.2. | Remove the wiring protector. |
| 4.3. | Disconnect the retaining clip (3) from the lock housing
cover sleeve. |
| 4.4. | Pull the wire harness (4) through the steering column. |
| 4.5. | Remove the lock cylinder (1) from the steering column. |
Installation Procedure
- Install the lock cylinder (1)
and harness (4), perform the following:
| 1.1. | Install the lock cylinder (1) to the vehicle. |
| 1.2. | Pull the wire harness (4) through the steering column. |
| 1.3. | Connect the retaining clip (3) to the lock housing cover
sleeve. |
| 1.4. | Install the wiring protector. |
| 1.5. | Connect the terminal connector to the bulkhead connector. |
Notice: Use the correct fastener in the correct location. Replacement fasteners
must be the correct part number for that application. Fasteners requiring
replacement or fasteners requiring the use of thread locking compound or sealant
are identified in the service procedure. Do not use paints, lubricants, or
corrosion inhibitors on fasteners or fastener joint surfaces unless specified.
These coatings affect fastener torque and joint clamping force and may damage
the fastener. Use the correct tightening sequence and specifications when
installing fasteners in order to avoid damage to parts and systems.
- Install the lock
retaining screw (2).
Tighten
Tighten the lock retaining screw to 2.5 N·m (22 lb in).
- Remove the ignition key
from the lock cylinder.
- Install the steering wheel to the steering column. Refer to
Steering Wheel Replacement
.
