GM Service Manual Online
For 1990-2009 cars only

Removal Procedure


    Object Number: 451525  Size: SH

    Notice: Avoid spilling brake fluid onto painted surfaces, electrical connections, wiring, or cables. Brake fluid will damage painted surfaces and cause corrosion to electrical components. If any brake fluid comes in contact with painted surfaces, immediately flush the area with water. If any brake fluid comes in contact with electrical connections, wiring, or cables, use a clean shop cloth to wipe away the fluid.

  1. Remove and discard the brake fluid from the reservoir.

  2. Object Number: 222987  Size: SH
  3. Remove the combination valve pipes in order to prevent fluid loss and contamination.
  4. Disconnect the brake fluid level sensor connector.
  5. Remove the master cylinder nuts.
  6. Remove the master cylinder.

Installation Procedure


    Object Number: 222987  Size: SH
  1. Bench bleed the master cylinder. Refer to Master Cylinder Bench Bleeding .
  2. Install the master cylinder.
  3. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  4. Install the master cylinder nuts.
  5. Tighten
    Tighten the master cylinder nuts to 29 N·m (21 lb ft).

  6. Fill the master cylinder reservoir. Refer to Master Cylinder Reservoir Filling .
  7. Install the brake combination valve pipes onto the master cylinder one at a time. Complete the following steps:
  8. 5.1. Remove the locally fabricated plugs.
    5.2. Install the brake pipe fitting finger tight.
    5.3. Have an assistant depress the brake pedal in order to remove air at the loose brake pipe fittings.

    Tighten
    Tighten the combination valve pipe fittings to 32 N·m (24 lb ft).

    5.4. Have an assistant quickly release and pump the brake pedal several times.
    5.5. If the brake pedal remains high and firm, start the vehicle. If the brake pedal still feels firm, test drive the vehicle.

    If the brake pedal feels soft or spongy, bleed the entire brake hydraulic system. Refer to Hydraulic Brake System Bleeding .

  9. Connect the brake fluid level sensor connector.