Caution: This vehicle is equipped with a Supplemental Inflatable Restraint (SIR) System. Failure to follow the correct procedure could cause the following conditions:
• | Unnecessary SIR system repairs |
In order to avoid the above conditions, observe the following guidelines:
• | Refer to SIR Component Views in order to determine if you are performing service on or near the SIR components or the SIR wiring. |
• | If you are performing service on or near the SIR components or the SIR wiring, disable the SIR system. Refer to Disabling the SIR System. |
- Disable the inflatable
restraint steering wheel module. Refer to
Disabling the SIR System
in SIR.
- Remove the tilt lever. Refer to
Tilt Lever Replacement - On Vehicle
.
- Remove the turn signal and multifunction lever. Refer to
Multifunction Turn Signal Lever Replacement - On Vehicle
.
- Remove the hazard knob. Refer to
Hazard Warning Switch Replacement
.
- Remove the turn signal cancel cam and upper bearing inner race.
Refer to
Turn Signal Cancel Cam and Upper Bearing Inner Race - Disassemble - Off Vehicle
.
- Remove the round washer head screw (2) from the signal
switch arm assembly (3).
- Pry out the signal switch arm assembly (3) from the lock
housing cover and sleeve assembly.
- Remove the 3 pan head 6-lobed socket screws (1)
from the turn signal and multifunction switch assembly.
- In order to remove the
turn signal and multifunction switch assembly, use the following steps:
9.1. | Remove the steering column wire harness strap. |
9.2. | Remove the wiring protector. |
- Disconnect the terminal
connector from the turn signal and multifunction switch assembly connector.
- Pull the turn signal and multifunction switch assembly connector
through the steering column, if needed.