Front Seat Replacement - Bucket Manual

1. Place a protective tape over the nearby trim and paint.
2. Remove the caps (3) from seat adjuster nuts (4).
3. Remove the seat adjuster nuts (4) from the studs (2, 5).
4. Disconnect the seat belt wiring harness electrical connector, as required.
5. Remove the front bucket seat (1) from the vehicle.

1. Install the front bucket seat (1) on to the studs (2, 5) in the vehicle.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Install the seat adjuster nuts (4) to the studs (2, 5).

Tighten
Tighten the seat adjuster nuts to 50 N·m (37 lb ft).

3. Connect the seat belt wiring harness electrical connector, if required.
4. Install the caps (3) to the nuts (4).
5. Remove the protective tape from the nearby trim and paint.

Front Seat Replacement - Bucket Power

1. Place a protective tape over the nearby trim and paint.
2. Position the front power bucket seat to the full upward and midway position.



3. Remove the screws from the inner and outer front adjuster nut covers, and remove the covers.



4. Remove the screw from the rear inner adjuster nut cover, and remove the cover.



5. Remove the screw from the rear outer adjuster nut cover, position the cover to access the adjuster nut.



6. Remove the seat adjuster nuts from the studs.



7. Disconnect the seat belt wiring harness electrical connector, and the lumbar air supply hose.



8. Remove the front bucket seat from the vehicle.

1. Install the front bucket seat to the vehicle.



2. Connect the seat belt wiring harness electrical connector, and the lumbar air supply hose.




Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

3. Install the seat adjuster nuts to the studs.

Tighten
Tighten the nuts to 50 N·m (37 lb ft).




4. Install the screw to the rear outer adjuster nut cover.

Tighten
Tighten the screw to 2 N·m (18 lb in).




5. Install the rear inner adjuster nut cover and install the screw to the cover.

Tighten
Tighten the screw to 2 N·m (18 lb in).




6. Install the inner and outer front adjuster nut covers, and install the screws to the covers.

Tighten
Tighten the screws to 2 N·m (18 lb in).

7. Position the front power bucket seat to the original setting.
8. Remove the protective tape from the nearby trim and paint.