Front Fog Lamp Bulb Replacement Camaro-Firebird

Caution: Halogen bulbs contain gas under pressure. Handling a bulb improperly could cause it to shatter into flying glass fragments. To help avoid personal injury:

•	Turn off the lamp switch and allow the bulb to cool before changing the bulb.

•	Leave the lamp switch OFF until the bulb change is complete.

•	Always wear eye protection when changing a halogen bulb.

•	Handle the bulb only by its base. Avoid touching the glass.

•	Keep dirt and moisture off the bulb.

•	Properly dispose of the used bulb.

•	Keep halogen bulbs out of the reach of children.

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
2. Open the access door (2) in the front bumper air deflector.
3. Disconnect the electrical connector from the fog lamp bulb/socket.
4. Remove the fog lamp bulb/socket from the fog lamp (1).

1. Install the fog lamp bulb/socket to the fog lamp (1).
2. Connect the electrical connector to the fog lamp bulb/socket.
3. Close the access door (2) in the front bumper air deflector.
4. Lower the vehicle.

Front Fog Lamp Bulb Replacement Trans Am

Caution: Halogen bulbs contain gas under pressure. Handling a bulb improperly could cause it to shatter into flying glass fragments. To help avoid personal injury:

•	Turn off the lamp switch and allow the bulb to cool before changing the bulb.

•	Leave the lamp switch OFF until the bulb change is complete.

•	Always wear eye protection when changing a halogen bulb.

•	Handle the bulb only by its base. Avoid touching the glass.

•	Keep dirt and moisture off the bulb.

•	Properly dispose of the used bulb.

•	Keep halogen bulbs out of the reach of children.

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
2. Remove the push pin retainers which are located at the bottom center of the front fascia.
3. Disconnect the electrical connector from the fog lamp bulb/socket.
4. Remove the fog lamp bulb/socket from the fog lamp (1).

1. Install the fog lamp bulb/socket to the fog lamp (1).
2. Connect the electrical connector to the fog lamp bulb/socket.
3. Install the push pin retainers to the bottom center of the front fascia.
4. Lower the vehicle.