- Remove the parking brake lever trim bezel. Refer to Instrument Panel, Gages and Console in Body and Accessories.
- Loosen or tighten the locknut (3) until the parking brake is applied with 3 to 6 clicks and 20 kg (44 lb) of force.
- Install the parking brake lever trim bezel. Refer to Instrument Panel, Gages and Console in Body and Accessories.
Notice: Use care when performing service operations on or around parking brake cables. Damage to the plastic coating will reduce corrosion protection and if the damaged area passes through the seal, increased parking brake effort could result. Contacting the coating with sharp-edged tools, or with sharp surfaces of the vehicle underbody, should be avoided.
Important: Ensure that the following conditions are met before cable adjustment:
• No air is trapped in the brake system. Refer to
Hydraulic Brake System Bleeding
in Brakes. • Brake pedal travel is within specifications. Refer to
Hydraulic Brake System Bleeding
in Brakes. • Brake pedal travel has been pressed 3 to 10 times with about 30 kg
(66 lb) of force. • The parking brake lever has been pulled up 3 to 10 times with
about 20 kg (44 lb) of force and completely released. • The rear brake shoes are not worn beyond the limit and self-adjusting
mechanism operates properly. Refer to Drum Brakes.
