Diagnostic Instructions
| • | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
| • | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
| • | Diagnostic Procedure Instructions provides an overview of each diagnostic category. |
DTC Descriptor
DTC P0513: Theft Deterrent Key IncorrectCircuit/System Description
The theft deterrent module (TDM) sends the prerelease password to the engine control module (ECM) via the serial data circuit. The ECM then sends a challenge to the TDM. Both the ECM and TDM perform a calculation on this challenge. If the calculated response from the TDM equals the calculation performed by the ECM, the ECM will allow vehicle starting.
Conditions for Running the DTC
Ignition is in the ACCESSORY or RUN position.
Conditions for Setting the DTC
The calculated response from the TDM does not equal the calculation performed by the ECM.
Action Taken When the DTC Sets
DTC P0513 is type C DTC.
Conditions for Clearing the DTC
DTC P0513 is type C DTC.
Diagnostic Aids
The "key" referenced in the DTC descriptor does not refer to the vehicle key. In this case, "key" is referring to the challenge response.
Reference Information
Schematic Reference
Connector End View Reference
Description and Operation
Immobilizer Description and Operation
Electrical Information Reference
Scan Tool Reference
Control Module References for scan tool information
Circuit/System Verification
Important: Because of normal system communications between the TDM and ECM, any theft deterrent B-codes must be diagnosed prior to the diagnosis of P-codes.
Perform the 10-Minute Immobilizer Relearn procedure. Refer to Immobilizer System Component Programming. The ECM should successfully complete the password learn and the vehicle should start.
| ⇒ | If the ECM does not complete the learn or vehicle starting remains disabled, replace the ECM. |
Repair Instructions
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
Control Module References for ECM replacement, setup, and programming
