GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Pontiac 🢒 2008 🢒 G5 🢒 Brakes 🢒 Hydraulic Brakes 🢒 Brake Drum Surface and Wear Inspection

Tools Required

J 8001 Dial Indicator, or equivalent

Caution: Refer to Brake Dust Caution in the Preface section.

  1. With the brake drum removed, clean the brake shoe lining contact surface of the brake drum with denatured alcohol or an equivalent approved brake cleaner.
  2. Inspect the braking surface of the brake drum for the following Braking Surface Conditions:
    3. • Heavy rust and/or pitting
    • Light surface rust can be removed with an abrasive disc; heavy surface rust and/or pitting must be removed by refinishing the drum.
    • Cracks and/or heat spots
    • Excessive blueing discoloration
    • Missing balance weights
  3. If the braking surface of the brake drum exhibits one or more of the Braking Surface Conditions listed, the drum requires refinishing or replacement.

    4. Object Number: 693345 Size: SH
  4. Using a brake drum micrometer calibrated in thousanths-of-an-inch, measure and record any grooves present on the drum braking surface.

    5. Ensure that the measurements are only taken within the brake shoe lining contact area.

  5. Compare the groove, or scoring depth recorded to the following specification:

    6. Specification
    Brake drum maximum allowable scoring: 1.5 mm (0.059 in).

  6. If the brake drum scoring depth exceeds the specification, or if an excessive amount of scoring is present, the drum requires refinishing or replacement.
  7. Mount the brake drum on a brake lathe.
  8. Mount a dial indicator, J 8001 or equivalent, and position the indicator button so it contacts the braking surface of the brake drum at a 90 degree angle, approximately 19 mm (0.75 in) from the outer edge of the drum.
  9. Measure and record the radial runout of the brake drum.
    10. 9.1. Rotate the drum until the lowest reading is displayed on the indicator dial, then zero the dial.
    9.2. Rotate the drum until the highest reading is displayed on the dial.
  10. Compare the radial runout of the brake drum to the following specification:

    11. Specification
    Brake drum maximum allowable radial runout: 0.104 mm (0.004 in).

  11. If the brake drum radial runout exceeds the specification, the drum requires refinishing or replacement.