Engine Block Assemble 2.2L

1. Install the drain plug in the water pump.
2. Apply sealer GM P/N 12346004 (Canadian P/N 10953480) to the plug before installation.

Caution: Refer to Fastener Caution in the Preface section.

3. Install the coolant jacket plugs and tighten to 35 N·m (26 lb ft).
4. Apply sealer GM P/N 12346004 (Canadian P/N 10953480 to the plugs before installation.
5. Install the rear oil passage plugs and tighten to 60 N·m (44 lb ft).
6. Install the other oil passage plugs and tighten to 35 N·m (26 lb ft).



7. Lubricate the crankshaft position sensor O-ring with engine oil.
8. Install the crankshaft position sensor and bolt and tighten to 10 N·m (89 lb in).



9. Install the oil pressure switch and tighten to 26 N·m (19 lb in).



10. Install the knock sensor and bolt and tighten to 25 N·m (18 lb ft).