S14 is the Folding Top Front Latch Actuator Position switch. The Folding Top Control (FTC) Module uses S14 to determine when the top is latched in both the open and closed positions. S14 closes and pulls the signal circuit low when the top is latched.

The Folding Top is being commanded.

The top may be disabled and will not operate properly.

The fault is no longer present and the top completes one cycle.

Schematic Reference

Folding Top Schematics

Connector End View Reference

Power Roof Systems Connector End Views

Description and Operation

Power Folding Top Description and Operation

Electrical Information Reference

Scan Tool Reference

Scan Tool Output Controls

Scan Tool Data List

Scan Tool Data Definitions

1. Disconnect S14.
2. Ignition ON, probe the signal circuit of S14 with a test lamp connected to ground. The test lamp should illuminate.

⇒	It the test lamp does not illuminate, test for an open or short to ground on the signal circuit.

⇒	If circuit tests OK, replace FTC Module.

3. Use a scan tool to monitor the Folding Top Bell Crank Sw. parameter.
4. Connect a fused jumper wire between the signal circuit and the low reference circuit of S14. The scan tool should indicate Over Center.

⇒	If the scan tool does not indicate Over Center, test the low reference circuit for an open or high resistance.

⇒	If circuit tests OK, replace FTC Module.

5. If circuits test OK, replace S14.

Perform the Diagnostic Repair Verification after completing the diagnostic procedure.

Folding Top Front Latch Actuator Position Switch Replacement

Folding Top Control Module Replacement