Tail Lamp Assembly and /or Backup, Sidemarker, Stop, Turn Signal Bulb Replacement. Pontiac G6 2006

For 1990-2009 cars only

Makes 🢒 Pontiac 🢒 2006 🢒 G6 🢒 Body 🢒 Wiring Systems 🢒 Tail Lamp Assembly and /or Backup, Sidemarker, Stop, Turn Signal Bulb Replacement

Tail Lamp Assembly and /or Backup, Sidemarker, Stop, Turn Signal Bulb Replacement Convertible

Callout	Component Name
Notice: Refer to Fastener Notice in the Preface section. Fastener Tightening Specifications: Refer to Fastener Tightening Specifications . Preliminary Procedure Remove either the LR or RR compartment trim panel. Refer to Rear Compartment Trim Panel Replacement .
1	Nut, Tail Lamp (Qty: 1) Tighten 2 N·m (18 lb in)
2	Retainers, Tail Lamp (Qty: 2)
3	Lamp Assembly, Tail Tip Slide lamp housing over retainers to secure to body.

Callout	Component Name
Notice: Refer to Fastener Notice in the Preface section. Fastener Tightening Specifications: Refer to Fastener Tightening Specifications . Preliminary Procedure Pull back either the LR or RR compartment trim panel. Refer to Rear Compartment Trim Panel Replacement .
1	Nuts, Tail Lamp (Qty: 3) Tighten 2 N·m (18 lb in)
2	Lamp Assembly, Tail Tip Pull lamp outboard and disconnect the electrical connector.

Callout

Component Name

Notice: Refer to Fastener Notice in the Preface section.

Fastener Tightening Specifications: Refer to Fastener Tightening Specifications .

Pull back either the LR or RR compartment trim panel. Refer to Rear Compartment Trim Panel Replacement .

Nuts, Tail Lamp (Qty: 3)

Tighten
2 N·m (18 lb in)

Lamp Assembly, Tail

Tip
Pull lamp outboard and disconnect the electrical connector.

Callout	Component Name
Notice: Refer to Fastener Notice in the Preface section. Fastener Tightening Specifications: Refer to Fastener Tightening Specifications . Preliminary Procedure Remove either the LR or RR trunk liner. Refer to Rear Compartment Trim Panel Replacement .
1	Nuts, Tail Lamp Assembly (Qty: 2) Tighten 2 N·m (18 lb in) Tip Tighten nuts in sequence as shown.
2	Locator, Tail Lamp to Rear End Panel Tip Pull lamp rearward to disconnect the lamp locator, then disconnect the electrical connector.
3	Lamp Assembly, Tail Tip Connect electrical connector and locate upper outboard lamp locator to retainer in rear end panel, then push lamp inward in order to secure the locator.