Sunroof Switch Replacement C3Y
Removal Procedure
Caution: Refer to Eye Protection Caution in the Preface section.
Caution: Refer to Folding Top Hydraulic Pressure Caution in the Preface section.
Notice: Refer to Cylinder Hoses Notice in the Preface section.
- Manually open the folding top so that the folding top panel is resting unlatched on the windshield header.
- Place a protective covering over the interior and the adjacent body panels.
Disassembly Procedure
Important: Once the cylinder hose or the port plug has been removed, do NOT move the cylinder rod. This will cause fluid to squirt out of the ports.
- Ensure that the ignition switch is in the OFF position and that the folding top has not been operated under power for at least 6 minutes.
- Remove the reservoir filler plug.
- Using a small flat-bladed tool, release the retainer clip (1) from one of the cylinder hoses.
Important: Before disconnecting the cylinder hoses, have the replacement cylinder ready.
- Remove the cylinder hose retainer clip (1).
- Remove the cylinder hose (1). Use a clean shop towel to control any hydraulic fluid leakage.
- Remove the cylinder hose O-ring (1).
Important: Replacement cylinders are filled with fluid. Do NOT remove the port plug from the cylinder until you are ready to connect the cylinder hose.
- Using a small flat-bladed tool, release one of the port plug retainer clips from the replacement cylinder.
- Remove the retainer clips from the replacement cylinder.
- Remove the port plug from the replacement cylinder.
- Remove the port plug O-ring from the replacement cylinder.
Assembly Procedure
- Install a new O-ring (1) onto the cylinder hose (2).
- Install the hose (2) into the cylinder port (3). Press down on the hose until the hose is fully seated in the cylinder.
- Install anew cylinder hose retainer clip (1). Inspect the retainer clip to ensure that the clip is fully seated around the hose (2).
- Install the reservoir filler plug (1).
Installation Procedure
- Bleed the hydraulic system. Refer to
Folding Top Hydraulic System Bleeding Procedure .
- Inspect the hydraulic system for fluid leaks.
- Inspect the fluid level of the hydraulic system and add fluid as needed. Refer to
Folding Top Fluid Addition .
- Remove the protective covering.
Sunroof Switch Replacement CF5
Removal Procedure
- Remove the overhead console cover. Refer to
Roof Console Replacement.
- Disconnect the electrical connector from the sunroof control switch.
- Using a small flat-bladed tool disengage the sunroof control switch from the overhead console cover.
Installation Procedure
- Install the sunroof control switch into the overhead console cover. Press the switch into place until fully seated.
- Connect the electrical connector to the sunroof control switch.
- Install the overhead console cover. Refer to
Roof Console Replacement.