Removal Procedure
- Remove the fuse labeled HVAC CTRL (BATT).
- Completely open the instrument panel (I/P) compartment door by pressing
both tabs that support the stop bumpers. Refer to
Instrument Panel Compartment Replacement .
- Remove the air temperature actuator screws.
- Remove the air temperature actuator.
- Disconnect the air temperature actuator electrical connector.
Installation Procedure
- Connect the air temperature actuator electrical connector.
- Install the air temperature actuator.
Notice: Refer to Fastener Notice in the Preface section.
- Install the air temperature actuator screws.
Tighten
Tighten the screws to 1.5 N·m (13 lb in).
- Close the I/P compartment door. Refer to
Instrument Panel Compartment Replacement .
- Install the fuse labeled HVAC CTRL (BATT).