Diagnostic Instructions
| • | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
| • | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
| • | Diagnostic Procedure Instructions provides an overview of each diagnostic category. |
DTC Descriptors
DTC B1325 03 : Voltage Below ThresholdDTC B1325 07: Voltage Above Threshold
Diagnostic Fault Information
Circuit | Short to Ground | Open/High Resistance | Short to Voltage | Signal Performance |
|---|---|---|---|---|
Battery Positive Voltage Circuit | B1325 | B1325 | B1325 | B1325 |
Circuit/System Description
The control modules on this vehicle monitor the battery voltage through the battery positive voltage circuits. This vehicle has multiple modules that will set the DTC. For more information on which modules, refer to Diagnostic Trouble Code (DTC) List - Vehicle .
Conditions for Running the DTC
| • | The voltages supplied to the control modules are in the range of 7-26 volts. |
| • | The ignition is ON. |
| • | The engine is running. |
Conditions for Setting the DTC
B1325 03
The control module detects a system voltage below the calibrated value usually 9 volts for at least 5 seconds.
B1325 07
The control module detects a system voltage above the calibrated value usually 18 volts for at least 5 seconds.
Action Taken When the DTC Sets
| • | The control module immediately disables all outputs when an out of range voltage condition has been detected, with the exception of GMLAN and Run/Crank relay that are disabled after a 3 minute delay. |
| • | The setting of other DTCs is inhibited. |
Conditions for Clearing the DTC
The DTC clears when the malfunction is no longer present.
Reference Information
Schematic Reference
Starting and Charging Schematics
Connector End View Reference
Engine Electrical Connector End Views
Description and Operation
Charging System Description and Operation
Electrical Information Reference
Diagnostic Aids
| • | A possible cause of this DTC could be overcharging with a battery charger or jump starting. |
| • | A high voltage value in multiple modules indicates a concern in the charging system. |
Circuit/System Verification
With the scan tool installed, ignition On and the engine running, observe the Battery Positive Voltage parameter in the data list of the module setting the DTC. The reading should be between 9 volts and 18 volts.
Circuit/System Testing
- If the DTC is history refer to Charging System Test .
- Ignition On and the engine running, test for 9.5-17.5 volts between the battery positive voltage and the ground circuits of the affected module.
- If all the circuits test normal, test or replace the affected module.
| ⇒ | If not within the specified range test the B+ circuits for a short to ground or an open/high resistance, and the ground circuits for a open/high resistance. |
Repair Instructions
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
Control Module References for the affected module replacement, setup, and programming.
