Tools Required

J 39194-B Heated Oxygen Sensor Wrench

Notice: Refer to Heated Oxygen Sensor Resistance Learn Reset Notice in the Preface section.

1. Remove the intake manifold cover. Refer to Intake Manifold Cover Replacement .
2. Remove the connector position assurance (CPA) retainer (2).
3. Disconnect the heated oxygen sensor (HO2S) (1) electrical connector.
4. Remove the HO2S clip from the ignition control module bracket.




Important: The HO2S may be difficult to remove when the engine temperature is less than 48°C (120°F). Excessive force may damage the threads in the exhaust manifold.

5. Remove the HO2S using the J 39194-B .

Important : A special anti-seize compound is used on the HO2S threads. The compound consists of graphite suspended in fluid and glass beads. The graphite will burn away, but the glass beads will remain, making the sensor easier to remove. New or service sensors will already have the compound applied to the threads. If a sensor is removed from an engine and is to be reinstalled, the threads must have anti-seize compound applied before the reinstallation.

1. Coat the threads of the HO2S with anti-seize compound GM P/N 12377953 or equivalent, if necessary.

Notice: Refer to Fastener Notice in the Preface section.

2. Install the HO2S.

Tighten
Tighten the sensor to 42 N·m (31 lb ft) using the J 39194-B .




3. Connect the HO2S (1) electrical connector.
4. Install the CPA retainer (2).
5. Install the HO2S clip to the ignition control module bracket.
6. Install the intake manifold cover. Refer to Intake Manifold Cover Replacement .