Transmission Control Module Replacement. Pontiac G6 2008

For 1990-2009 cars only

Makes 🢒 Pontiac 🢒 2008 🢒 G6 🢒 Power and Signal Distribution 🢒 Data Communications 🢒 Transmission Control Module Replacement

Callout

Component Name

Transmission Control Module (TCM)

Procedure

•	Disconnect the TCM electrical connector.

•	The TCM must be programmed when replaced. Refer to Control Module References for programming and setup information.

Tip

•	Twisting or tilting of the transmission control module electrical connector while disconnecting may result in bent or misaligned electrical terminal pins.

•

It is recommended that transmission adaptive pressure (TAP) information be reset. Resetting the TAP values using a scan tool will erase all learned values in all cells. As a result, The ECM, PCM or TCM will need to relearn TAP values. Transmission performance may be affected as new TAP values are learned. Reset the TAP values. Refer to Transmission Adaptive Functions .

TCM Bracket Bolt

Notice: Refer to Fastener Notice in the Preface section.

Tighten
10 N·m (89 lb in)

TCM Bracket