J 41712 Oil Pressure Switch Socket.

1. Disconnect the oil pressure sensor wiring harness connector (1).




Important: Clean the area around the oil pressure sensor (2) before removal. This prevents debris from entering the engine.

2. Use the J 41712  (1) to remove the oil pressure sensor (2).

Notice: Refer to Fastener Notice in the Preface section.





Important: If installing the old oil pressure sensor (2), apply sealant GM P/N 12346004 (Canadian P/N 10953480) or equivalent to the cleaned oil pressure sensor (2) thread.

1. Install the oil pressure sensor (2) using the J 41712  (1).

Tighten
Tighten the sensor to 35 N·m (26 lb ft).




2. Connect the oil pressure sensor electrical connector (1).