Retained Accessory Power (RAP)
The retained accessory power (RAP) system allows certain vehicle functions to operate for a specific amount of time after the ignition switch is turned OFF. The body control module (BCM) monitors the ignition switch position, battery condition, and each
door ajar switch status to determine whether RAP should be initiated or terminated. RAP is controlled with two different methods; serial data and relay control. Some modules receive a RAP message from the BCM over the serial data circuits. Serial data controlled
RAP is deactivated as required by their modules RAP power mode operation. Other subsystems are activated directly by the BCM through a RAP relay. Components and systems that are active in RAP are also activated anytime the ignition is any position other than
OFF regardless of the door switch signals.
Relay Controlled RAP
The BCM keeps the RAP relay energized during all power modes, except Off-Awake and Crank. The relay is also energized for approximately 10 minutes after shutting the ignition OFF and removing the key, providing no door is opened.
Relay controlled RAP will end when one of the following conditions is met:
| • | The BCM receives an input from any door ajar switch indicating the opening of any door after the ignition key is out of the ignition. |
| | Important: If the BCM is receiving any door ajar signal from those switches when the ignition key is turned OFF, RAP will not initiate.
|
| • | The BCM internal timer for the RAP expires after approximately 10 minutes. |
| • | The BCM detects a decrease in battery capacity below a calibrated limit. |
Systems powered during the RAP power mode are as follows:
| • | Accessory power outlet center console compartment |
| • | Accessory power outlet - I/P |
| • | Door lock / window switch |
Serial Data Controlled RAP
RAP systems controlled by serial data are as follows:
Radio
Radio RAP activation/termination is the same as relay operation with two exceptions:
| • | The timer for the Radio RAP is approximately 45 minutes. |
| • | The only door switch that will turn off the radio during RAP is the driver door open switch. |
Vehicle Communication Interface Module (VCIM) (Onstar®)
VCIM RAP activation/termination is the same as radio operation with one exception; if there is an active call when the ignition key is turned off the VCIM will remain in RAP mode, and keep the radio in RAP mode until the call is terminated.
