Theft Deterrent Scan Tool Data Parameters
Parameter | Operating Conditions | Expected Value | Definition |
|---|---|---|---|
Ignition is ON, engine OFF, and vehicle is stationary | |||
Auto Learn Counter | -- | 0 counts | This displays Counts. This is the number of times the auto learn procedure was carried out by the TDM |
Auto Learn Timer | -- | 0:00 mins | This displays minutes. This is the amount of minutes the TDM took to auto learn. |
Fleet Vehicle | -- | Yes | The scan tool will display whether the vehicle is a fleet car. |
-- | No | ||
Learn Coded Key | -- | Yes | The scan tool will display whether the module has learned the code of the key in use. |
-- | No | ||
Ignition Voltage Signal | -- | Present | The scan tool displays Present or Not Present. Present is displayed if there is an ignition voltage signal to the TDM. |
Not Present | |||
Immobilisation | Immobilisation activated | Active | The scan tool displays Active or Inactive to indicate the status of the immobilisation. |
Immobilisation deactivated | Inactive | ||
Immobilizer Programmed | -- | Yes | The scan tool will display if the immobilizer is programmed or not. |
-- | No | ||
Master Keys Learned | -- | 2 counts | The scan tool will display the total number of keys programmed as master keys to the vehicle. |
PCM Auto Learn Timer | -- | Active | The scan tool displays Active or Inactive. This is the current state of the ECM auto learn timer. |
-- | Inactive | ||
PCM Password Learned | -- | Enabled | The scan tool displayed whether the fuel enabled password is enabled or disabled to the ECM |
-- | Disabled | ||
Power Mode | Ignition is in OFF position | Off | This parameter displays Off/Accessory/Run/Crank. This is the status of the system power mode dependent on the ignition position. |
Ignition is in ACC position | Accessory | ||
Ignition is in RUN position | Run | ||
Ignition is in CRANK position | Crank | ||
Powertrain DTC | -- | Yes | The scan tool displays Yes or No. Yes is displayed if there is a powertrain DTC stored in the ECM or TCM. |
-- | No | ||
Previous TDM State | -- | Learn Keys Standby | This was the last state of the TDM. |
-- | Wake up | ||
-- | Monitor Key | ||
Security Code Programmed | -- | Yes | The scan tool displays Yes or No. Yes is displayed if a security code is programmed. |
-- | No | ||
Start Disabled | -- | Yes | The scan tool displays Yes or No. Yes is displayed if the starter is disabled. |
-- | No | ||
Tamper Status | -- | Active | The scan tool displays whether theft is in the tamper state. |
Theft Deterrent Module (TDM) State | -- | Learn Keys Standby | This was the last state of the TDM. |
-- | Wake up | ||
-- | Monitor Key | ||
Telltale Status | -- | On | This is the state of the security indicator. |
-- | Off | ||
Theft Problem | -- | Yes | The scan tool displays Yes or No. Yes is displayed if there is a theft problem. |
-- | No | ||
Total Keys Learned | -- | 2 counts | This displays Counts. This is the number of total keys learned by the TDM. |
Transponder Key | -- | Present | The scan tool displays Present or Not Present. Present is displayed when a transponder is present. This does not mean that this is a valid or learned transponder, but only that a transponder is present. |
-- | Not Present | ||
Valid Key | -- | Yes | The scan tool displays Yes if a valid transponder key is present. |
No | |||
