Tools Required

J-42188-B

Caution: Refer to Safety Glasses Caution in the Preface section.

Caution: Refer to Vehicle Lifting Caution in the Preface section.

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
2. Remove the driver side front wheel. Refer to Tire and Wheel Removal and Installation.



3. Remove and discard the stabiliser bar link to stabiliser bar retaining nut (1).
4. Disconnect the stabiliser bar link (2) from the stabiliser bar (3).
5. Repeat steps 3 and 4 for the opposite side of the stabiliser bar.



6. Loosen the driver side tie rod end to steering knuckle retaining nut (1) about two turns.



7. Using J-42188-B  (1) disconnect the driver side tie rod end (3) from the steering knuckle (2).



8. Remove and discard the driver side tie rod end to steering knuckle retaining nut (1).
9. Separate the driver side tie rod end (3) from the steering knuckle (2).



10. Remove the air inlet duct.

•	For 3.6L engine refer to Air Cleaner Inlet Duct Replacement.

•	For 6.0L engine refer to Air Cleaner Inlet Duct Replacement.

11. Remove the power steering gear inlet pipe bracket to subframe retaining bolt (2).
12. Remove the power steering gear outlet pipe bracket to subframe retaining bolt (1).
13. Remove the stabliser bar insulators from the stabiliser bar. Refer to Stabilizer Shaft Insulator Replacement.
14. Remove the stabiliser bar from the vehicle.

Notice: Refer to Fastener Tightening Specifications in the Preface section.

1. Install the stabiliser bar to the vehicle.
2. Install the stabiliser bar insulators. Refer to Stabilizer Shaft Insulator Replacement.

Notice: Refer to Fastener Notice in the Preface section.




3. Install the power steering gear inlet pipe bracket to subframe retaining bolt (2).

Tighten
Tighten the bolt to 9 N·m (80 lb in).

4. Install the power steering gear outlet pipe bracket to subframe retaining bolt (1).

Tighten
Tighten the bolt to 9 N·m (80 lb ft).

5. Install the air inlet duct.

•	For 3.6L engine refer to Air Cleaner Inlet Duct Replacement.

•	For 6.0L engine refer to Air Cleaner Inlet Duct Replacement.




6. Connect the stabiliser bar link (2) to the stabiliser bar (3).
7. Install the NEW stabiliser bar link to stabiliser bar retaining nut (1).

Tighten
Tighten the nut to 50 N·m (37 lb ft).

8. Repeat steps 6 and 7 for the opposite side of the stabiliser bar.



9. Install the driver side tie rod end (3) to the steering knuckle (2).
10. Install the NEW driver side tie rod end to steering knuckle retaining nut (1).

Tighten
Tighten the nut to 70 N·m (52 lb ft).

11. Install the front wheel. Refer to Tire and Wheel Removal and Installation.
12. Lower the vehicle.