For 1990-2009 cars only
Removal Procedure - Side Indicator
- Disconnect the battery ground cable. Refer to Battery Negative Cable Disconnection and Connection .
- Remove side indicator lamp assembly from the fender by grasping the assembly and pushing the assembly forward to disengage the rear clip from the fender.
- Tilt the rear of the side indicator lamp assembly out and remove the assembly from the front fender.
- Disconnect the electrical connector from the bulb socket, by depressing the connector clip and pulling connector from bulb socket.
- Disconnect the bulb socket from the side indicator lamp assembly by rotating the socket counterclockwise.
- Remove the side indicator bulb from the bulb socket.
Caution: Refer to Battery Disconnect Caution in the Preface section.
Installation Procedure - Side Indicator
- Install a new side indicator bulb to the bulb socket.
- Connect electrical connector to the bulb socket, note orientation of the electrical connector.
- Install the bulb socket into the side indicator lamp assembly and rotate the socket clockwise to secure the bulb and socket.
- Install rear portion of the side indicator lamp assembly into the fender and then push the front of the lamp assembly inwards to engage the front clip.
- Connect the battery ground cable. Refer to Battery Negative Cable Disconnection and Connection .
- Check all vehicle lights for correct operation.
Important: The tabs on the bulb base and mating cut-outs in the lamp assembly allow the bulb to seat correctly in the lamp.
Caution: Refer to Battery Disconnect Caution in the Preface section.
