Removal Procedure
Important: Adjust the armrest (3) to a suitable
position to access the rear seat back cover retainer (1)
- Carefully pull down on the rear seat back cover retainer (1) and detach
the trim flap (4) from the trim flap retainers (2).
Important: Lift the rear folding seat cover (3)
to expose the armrest to rear folding seat back retaining bolts 4 and 5
Important: Do not remove the armrest to rear folding
seat back retaining bolts (5)
- Loosen the armrest to rear folding seat back retaining bolts (5) approximately
2 turns.
- Remove the armrest to rear folding seat back retaining bolts (4)
from the armrest hinges (2).
- Slide the armrest assembly (1) up
and away from the armrest to rear folding seat back retaining bolts (3).
- Remove the armrest assembly (1) from the rear folding seat assembly (2).
Installation Procedure
- Install the armrest assembly (1)
to the rear folding seat back assembly (2).
- Slide the armrest assembly (1) onto the armrest to rear folding
seat back retaining bolts (3).
Notice: Refer to Fastener Notice in the Preface section.
Important: Do not fully tighten the armrest to rear
folding seat back retaining bolts (3) at this stage.
- Tighten the armrest to rear folding seat back retaining bolts (3).
Important: Adjust the armrest (1) to access the
armrest to rear folding seat back retaining bolts (4).
- Install the armrest to rear folding seat back retaining bolts (4) to
the armrest hinges (2).
Tighten
Tighten to 4 N·m (35 lb in).
- Tighten the armrest to rear folding seat back retaining bolts (5).
Tighten
Tighten to 4 N·m (35 lb in).
- Lower and attach the trim flap (1) to the trim
flap retainers (2).